I personally would have never purchased a vivint security system (Not. Default installer code for vivint branded 2gig panel is 2203, be sure to. This article will explain how to add Z-wave devices to the Go!Control panel.

Hello, Thanks for helping me out – I picked up a 2GIG vivnit panel at a garage sale. The panel is model 2GIG-CP11-345E with software version 1.9.6. It has the 2GIG-REC2-345E receiver installed, backup battery and a cellular module which I determined is locked out and un-usable. All appears to be working OK except a major item (system configuration) access to add devices. I gained initial access using the duress code (user 8) and changed the user code for master user 1.

Next I accessed the toolbox using default code 2203 that I read about. So far so good – I thought! I gained access to the toolbox using code 2203, but once in, I went to select “system configuration” and it gives me the message that the “feature is locked and to contact tech support”. I read on the forum that vivint typically locked the panel programing with Q44-Q45, thereby not allowing or denying end users from making changes. I guess that is what I am experiencing and need help. Without access, I cannot add devices as you well know.

So, I next read on the forum that a hard reboot would “reset the panel to factory” and change the out of box installer code back to 1561. Reading posts on instructions on “how to” “take over” a panel back and get it back to factory settings I performed the following steps in hopes of achieving that with this panel. Here is what I did: (1) disconnected AC power source, (2) disconnect battery, (3) I also removed a known locked cell module-didn’t know if that mattered (4) pressed and held in the two front panel buttons while reconnecting the power (5) the panel rebooted, however the panel still does not allow me access to system configurations from the tool box. It appears that nothing has changed, the panel staying locked down with regard to system configuration. I have looked on line for another cell module in the meanwhile and did find one for instance on e-bay that I have used your alarm.com module check on – here is what it said: Your Alarm.com cellular module Removed by Administrator is unregistered and can be monitored by suretyCAM. Your module is a CDMA radio on the Verizon network running firmware version 601127 and is two way voice capable. Congratulations, your module has a 3G radio!

So, will installing this unit allow you at your end to remotely enter the system and fix the Q44 and Q45 lockouts that is keeping me from using this panel? Principialjnuyu shemu zaryadnogo ustrojstva orion pw260. I am not sure I will want to use monitoring with it at this point vs. Just something to make noise at a garage I have until I learn more of what it can do.